• How to identify Faults in injection molding

    How to identify Faults in injection molding

    The effect of the fault should be taken into account and when Plastic injection mould the cause has been identified the necessary steps should be take...

    03-12-2020 News
  • How to reduce the cost of injection molding plants

    How to reduce the cost of injection molding plants

    Carrying large Plastic injection mould stocks of a large variety of different materials in a wide range of grades and colours can be extremely expensi...

    26-11-2020 News
  • What is a three-plate plastic mold

    What is a three-plate plastic mold

    The three-plate mould differs from the more common two-plate design format in terms of utilizing more than one split or parting line. The tool constru...

    18-11-2020 News
  • What is the hardness of the plastic mold

    What is the hardness of the plastic mold

    In use, the hardness Plastic injection mould of economically operating molds is as low as 85 Rockwell "B" and as high as 65 Rockwell "C". At this poin...

    12-11-2020 News
  • How to make a plastic mold

    How to make a plastic mold

    The main Plastic injection mould process used is machining, where the shape to be generated is cut to the required size on a lathe or milling machine....

    06-11-2020 News
  • How to chose correct injection mould

    How to chose correct injection mould

    Plastic injection mould design types and configurations vary enormously due to the many technical requirements of the moulded components to be produce...

    29-10-2020 News
CONTACT US