Mold flow analysis can know whether the product has filling problems. For example, whether the product has short shots, bubbles, and unbalanced filling during the injection process can be determined by carefully analyzing the filling curve. In the mold flow analysis, you can change the position of the injection mold gate, injection speed and other processing conditions, so that you can know whether these problems can be improved or corrected.
Mold flow analysis can know whether the product is full. It can also provide other useful information such as the required maximum injection pressure and clamping pressure to provide a reference for us to choose an injection molding machine.Mold flow analysis can calculate the efficiency of the cooling circuit. Adding cooling analysis to deformation analysis can increase accuracy.
Since the cooling water circuit is difficult to modify once it is completed, this type of analysis is very useful before opening the mold.Can predict whether the product is deformed. The absolute value of the deformation is predicted and analyzed. The prediction of the deformation can be used to compare the gate position, wall thickness changes or design changes.
Can be used to check and correct problematic Plastic injection mould prototypes. The problem in detecting injection molds is to use mold prototypes to do "short shots". Mold flow analysis can determine which changes will be effective and faster and cost less than mold repair.
The mold injection molding cycle is short, high efficiency, long life and low cost.It adopts international advanced level special flow channel design,
An injection molding machine is a piece of equipment used to manufacture plastic products. It works by injecting molten plastic into a mold, then cool
Blowing mould – Plastic bottle Most plastic materials are PET& PE, which are formed by blow molding. High efficiency and high output can be achi
Cavity core steel: using StaVaxS420 manufactured by Assab, Sweden, it is stainless steel and tempered steel gate type: hot runner point gate product p
Handle Mould The handle has a side handle and a lifting handle on the neck of the bottle mouth, both to facilitate lifting the bottle. They are of var
PPR Pipe Fitting Mould PPR pipe fittings are used for pipe joints underground and deep in the building facade, which are divided into internal and ext
PVC Pipe Fitting Mould PVC pipe fittings with thin wall thickness are commonly used for water pipes. Most wire pipe valve connections use a size of 20
Copyright © 2016 Taizhou Huangyan Yongsheng Mould Co., Ltd. All Rights Reserved
Custom Plastic Injection Mold Manufacturers
English 
中文简体
Español
عربى