The maintenance personnel who are responsible for the daily maintenance of the mold must work carefully and carefully to ensure the best condition of the mold, and it has been expected to be effective and economical during production, and to reduce the manufacturing cost as much as possible. So how to complete the maintenance of the mold! Let’s learn with the editor below!
First of all, the maintenance instructions: when the injection mold is maintained, the parts need to be checked according to the drawings. Even if there is no special instruction, it must be checked when entering the warehouse; it is not allowed to modify the size of the mold parts that do not meet the drawings, or use spacers or gaskets for additional insertion, etc.; mold maintenance after the production order is completed , Must refer to the problem points provided by the production department, production department records and the final product; in the mold maintenance, if a major problem is found, it should immediately report to the supervisor and wait for instructions.
Secondly, the specific requirements for the maintenance of injection molds: when replacing mold parts, confirm that the quality of the replaced parts is qualified; disassemble and assemble each part to be tapped and slowly pressed; when assembling mold inserts, confirm that the fit gap is qualified; avoid the surface of the part No curls, scratches, pits, dross, defects, rust, etc.; if there are parts replacement, communicate and confirm with the mold design department in time. Before and after disassembly of the mold, pay attention to maintaining the balance of each part; if necessary, replace Parts must be replaced in time.
Finally, the daily maintenance of the injection mold must be carried out carefully and carefully to ensure that the mold is kept in the best condition at all times.
Blowing mould – Plastic bottle Most plastic materials are PET& PE, which are formed by blow molding. High efficiency and high output can be achi
Cavity core steel: using StaVaxS420 manufactured by Assab, Sweden, it is stainless steel and tempered steel gate type: hot runner point gate product p
Handle Mould The handle has a side handle and a lifting handle on the neck of the bottle mouth, both to facilitate lifting the bottle. They are of var
PPR Pipe Fitting Mould PPR pipe fittings are used for pipe joints underground and deep in the building facade, which are divided into internal and ext
PVC Pipe Fitting Mould PVC pipe fittings with thin wall thickness are commonly used for water pipes. Most wire pipe valve connections use a size of 20
Yongsheng adopts the world advanced designing software of CAD/UG/VT/STP the same time,Yongsheng introduced Austria latest advanced production technolo